[PSUBS-MAILIST] Fw: lathe arrives at new shop

[hank pronk via Personal_Submersibles]

Thanks Alan, yes the table will go up and down and side to side lolSean, I do not have three phase, my plan is to remove the 30 hp motor and drive the lathe with a 34hp Duetz diesel engine with commercial centrifugal clutch.  The engine will be outside the shop with a drive shaft through the wall.   Then I will buy a converter to drive the two small motors and controller.  Actually the controller might be single phase, lots of investigating to do.Hank 

    On Friday, July 14, 2017 6:04 PM, Sean T. Stevenson via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
 

 You have three phase service? or a converter?Sean


On July 14, 2017 5:26:28 PM MDT, hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
I can't believe it, one week ago I find and buy my 26,300 lb vertical lathe.  Today it has arrived at my new shop.  It will take at least 8 hr to jack and roll it off the low bed trailer.  After it is off and the truck is gone, I have to lower it and roll it into the shop, but first I have to remove the exterior wall and cut a hole in the ceiling of the shop.  There is a two bedroom apartment above the shop, so now there will be a section of lathe poking through  the living room floor.  I am renovating the exterior of the shop anyways.Hank

     On Friday, July 14, 2017 5:13 PM, xxx xxxxx <mp13 at live.ca> wrote:
 

  


   
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles


   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20170715/b901c179/attachment.html>