[PSUBS-MAILIST] Fw: lathe arrives at new shop

[Sean T. Stevenson via Personal_Submersibles]

You have three phase service? or a converter?

Sean


On July 14, 2017 5:26:28 PM MDT, hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
>I can't believe it, one week ago I find and buy my 26,300 lb vertical
>lathe.  Today it has arrived at my new shop.  It will take at least 8
>hr to jack and roll it off the low bed trailer.  After it is off and
>the truck is gone, I have to lower it and roll it into the shop, but
>first I have to remove the exterior wall and cut a hole in the ceiling
>of the shop.  There is a two bedroom apartment above the shop, so now
>there will be a section of lathe poking through  the living room floor.
> I am renovating the exterior of the shop anyways.Hank
>
>     On Friday, July 14, 2017 5:13 PM, xxx xxxxx <mp13 at live.ca> wrote:
> 
>
>  
>
>
>   
>
>------------------------------------------------------------------------
>
>_______________________________________________
>Personal_Submersibles mailing list
>Personal_Submersibles at psubs.org
>http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20170714/52fde4b5/attachment.html>