[PSUBS-MAILIST] G.L. summary Pressure Hull

[brian]

Is that so you don't have to compensate that area?
-----Original Message-----
From: "hank pronk" <hanker_20032000 at yahoo.ca>
Sent 12/12/2013 10:28:11 AM
To: "Personal Submersibles General Discussion" <personal_submersibles at psubs.org>
Subject: Re: [PSUBS-MAILIST] G.L. summary Pressure HullVance,I posted a picture of my new motor and seal assembly, (Gamma Restoration)  you can see I put  bearings and seals in the tail cone. You can't see it but I also have two ss lines that feed water to the shaft tube from outside the mbt.  This ensures the tube fills before I run the motor and also drains to prevent freezing.Hank On Thursday, December 12, 2013
10:31:05 AM, hank pronk <hanker_20032000 at yahoo.ca> wrote:Dan,Thank you, I will play around with it.  I guess that's how we learn.Hank On Thursday, December 12, 2013 9:48:21 AM,
Dan H. <jumachine at comcast.net> wrote:If you don't have a taper attachment, use the
compound slide on the lathe.  It's tricky to set since your working on
fractions of a degree for a good fit but you fine tune it with a few trial
pieces.   Dan H.----- Original Message ----- From:hank
pronkTo:Personal Submersibles General
DiscussionSent: Thursday, December 12, 2013 10:16
AMSubject: Re: [PSUBS-MAILIST] G.L. summary
Pressure HullDoes anyone have a trick to machining an inside taper without lathe
 attachments.  I need to make a hub to fit a tapered
shaft.  I made one by trial and error and it will work but it is not
perfect. Hank On Thursday, December 12, 2013 7:13:39
AM, Jon Wallace <jonw at psubs.org>
wrote:
I should have stated up
front that we were just having some fun and I hope nobody concentrating on
ROV/AUV development and operation takes offense.  PSUBS welcomes ROV and
AUV discussions here as well.
Jon
On 12/11/2013 9:57 PM, Alan James wrote:Thanks Keith,hope
didn't see the phone sex & ROV commentsearlier Keith
owns a ROV company.Alan_______________________________________________
Personal_Submersibles mailing listPersonal_Submersibles at psubs.orghttp://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
_______________________________________________
Personal_Submersibles
mailing
list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles_______________________________________________
Personal_Submersibles mailing listPersonal_Submersibles at psubs.orghttp://www.psubs.org/mailman/listinfo.cgi/personal_submersibles_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20131212/911e729d/attachment-0001.html>