<html><head></head><body><div style="color:#000; background-color:#fff; font-family:HelveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Grande, sans-serif;font-size:12px"><div><span>Brian,</span></div><div id="yui_3_16_0_ym19_1_1486001603772_4854"><span id="yui_3_16_0_ym19_1_1486001603772_4875">Make a speedy sleeve. No </span>biggy</div><div id="yui_3_16_0_ym19_1_1486001603772_4853">Hank</div> <div class="qtdSeparateBR"><br><br></div><div class="yahoo_quoted" style="display: block;"> <div style="font-family: HelveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Grande, sans-serif; font-size: 12px;"> <div style="font-family: HelveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Grande, sans-serif; font-size: 16px;"> <div dir="ltr"><font size="2" face="Arial"> On Wednesday, February 1, 2017 6:45 PM, Brian Cox via Personal_Submersibles <personal_submersibles@psubs.org> wrote:<br></font></div> <br><br> <div class="y_msg_container"><div id="yiv3432077540"><div style="font-family:Arial, sans-serif;font-size:10pt;"><div>Hi All,</div><div> Got myself into bit of a bind, my 2.5" OD by 1" ID shaft bearing is fine, but it turns out that they don't make a seal that exact size. They have under and over , so what I might do is epoxy the two shaft seals together so I can get to where I need to be. They make a 2.5"OD by 1.25"ID seal; on my next motor pod I may change the propeller shaft to 1.25" just to make things easier !</div><div> </div><div>Brian </div></div>
</div><br>_______________________________________________<br>Personal_Submersibles mailing list<br><a ymailto="mailto:Personal_Submersibles@psubs.org" href="mailto:Personal_Submersibles@psubs.org">Personal_Submersibles@psubs.org</a><br><a href="http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles" target="_blank">http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles</a><br><br><br></div> </div> </div> </div></div></body></html>