[PSUBS-MAILIST] strain relief

[Jon Wallace via Personal_Submersibles]

 Rick, I think it would depend upon the specific application.  The nickel coating is not likely to last long term so if this is going someplace you can regularly inspect and replace it might work, but otherwise I'd stick to stainless.
Jon

    On Monday, November 30, 2020, 08:06:06 PM EST, Rick Patton via Personal_Submersibles <personal_submersibles at psubs.org> wrote:  
 
 Hank 
A company called Sealcon sells a strain relief fitting that is I guess made out of Brass that is plated with nickel. I have seen it in the boating community for parts but I am not sure what alloy it is made up of as Brass comes in different alloys, so was wondering in any of you have used a nickel plated strain relief fitting or knew anything about them?
Rick
On Mon, Nov 30, 2020 at 12:09 PM hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:

 Rick, what is that?Hank
    On Monday, November 30, 2020, 12:51:26 PM MST, Rick Patton via Personal_Submersibles <personal_submersibles at psubs.org> wrote:  
 
 I was wondering if it was OK to use a nickel plated brass strain relief fitting to pass a cable through?Rick_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
  _______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20201201/b6dc979f/attachment-0001.html>