[PSUBS-MAILIST] Alan's new motor

[hank pronk via Personal_Submersibles]

 Alan,I have had similar situation, the oil will still come up the tube.  The over pressure makes no difference, unless there is a piston or diaphragm blocking the oil.Hank
    On Wednesday, October 3, 2018, 2:53:29 AM MDT, Alan via Personal_Submersibles <personal_submersibles at psubs.org> wrote:  
 
 Hank,yes very patient "lol" as this might not be the final version.I have tested the motor out of the housing in a bucket of oil & establishedthat it could only be run at 30 Amps without overheating. It causes quite a turbulence running in oil with no prop on due to the open design of a rotating back section. It will want to force oil out of the housing & up the oil feed tube,but I am hoping the overpressure from my oil compensator will keep the oilin around the motor. Am learning a lot on each attempt.Alan


On 3/10/2018, at 9:06 PM, hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:


Alan, your patience is amazing.  I would be itching to test it before sending it away for anodizing.  Hank

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20181003/b2dd8a1d/attachment.html>