[PSUBS-MAILIST] Tube Bending Tips/Advice

[emile via Personal_Submersibles]

Hi Steve,

What is the diameter? HP Lines of 6 or 10 mm? 
Best is to use a bending tool for the specific diameter.

Br, Emile

-----Oorspronkelijk bericht-----
Van: Personal_Submersibles [mailto:personal_submersibles-bounces at psubs.org]
Namens Steve McQueen via Personal_Submersibles
Verzonden: vrijdag 9 maart 2018 16:33
Aan: Personal Submersibles General Discussion
Onderwerp: [PSUBS-MAILIST] Tube Bending Tips/Advice

Getting ready to take some very straight SS tubing and bend it for
installation.  Never bent tubing before but I have a small hand bender and
an idea. I was thinking on using something rigid but something I could
form/bend by hand (heavy wire?) and make a template to then bend the final
piece against.

Looking for advice form those who have done this.

Thanks,
Steve
_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles