[PSUBS-MAILIST] O-ring groove machining

[Brian Cox via Personal_Submersibles]

Hi Alan, you can use a tiny file, but be careful it doesn't kick back at you.

--- personal_submersibles at psubs.org wrote:

From: Alan via Personal_Submersibles <personal_submersibles at psubs.org>
To: personal_submersibles at psubs.org
Subject: [PSUBS-MAILIST] O-ring groove machining
Date: Sat, 25 Feb 2017 12:41:39 +1300

Am cutting some small o-ring grooves in aluminum, 3.4mm x 2mm deep for
a 2.5mm D o-ring. ( 10th of an inch) What is the best way to remove the sharp 
corners of the grove? I have read that you can spin your work in the lathe
& sand with 200 & then 400 grit sand paper. Is this right?
Have been having fun making the tool for this & don't think I have done a 
good job! Am I best to buy a carbide tool specific for this job.
Thanks, Alan

Sent from my iPad

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles