[PSUBS-MAILIST] Oil Compensator

[Alan via Personal_Submersibles]

Jon,
an easy solution is to take the thruster, or that section of the thruster
in to a plumbing merchant or hydraulic repair shop & ask for something 
compatible with a barbed hose fitting. Sometimes a metric option will
fit in an imperial thread, & so they may know of not so obvious solutions.
Alan

Sent from my iPad

> On 14/04/2017, at 12:53 PM, Jon Wallace via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
> 
> Hi Hank,
> 
> No, I don't have the shaft, I purchased just the lower head.  A 36 inch shaft is $28 but like you said, I really only need a few inches of it so don't really want to purchase it that way.
> 
> Jon
> 
> 
> On Thursday, April 13, 2017 8:27 PM, hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
> 
> 
> Jon, 
> Do you have the shaft that used to screw into the motor?  if so, you can cut it down to a couple inches long and put a waterline compression fitting on that.   Then reduce from the compression pipe thread.  Or you can thread the inside of that stub shaft with a pipe tap and reduce from that, providing it is the heave fibreglass shaft.
> Hank
> 
> 
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20170414/d154f6a3/attachment.html>