[PSUBS-MAILIST] thru hulls

[hank pronk via Personal_Submersibles]

Brian,
Gamma has 1/8 orings, I would go with 1/8 might be more forgiveness.
Hank 
--------------------------------------------
On Tue, 3/17/15, Brian Cox via Personal_Submersibles <personal_submersibles at psubs.org> wrote:

 Subject: [PSUBS-MAILIST] thru hulls
 To: "PSubs" <personal_submersibles at psubs.org>
 Received: Tuesday, March 17, 2015, 3:31 PM
 
 Hi
 All,             
 Starting in on thru hull production.  I will need
 probably close to a dozen of them.  I'm making them
 all to accept a 1/2" stainless shaft, and I will be
 using 1/16"  O rings.  I don't see any
 need to use thicker diameter O
 rings ,  since the deeper O ring grooves
 can be a bit more problematic.   By the time my
 welder finishes all the remaining critical welds I should
 have my thru hulls done.   Also working on my
 forward hard ballast tank, approx. 18" in dia X 5'
 long
 .  Cheers, Brian 
   
 
 -----Inline Attachment Follows-----
 
 _______________________________________________
 Personal_Submersibles mailing list
 Personal_Submersibles at psubs.org
 http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles