[PSUBS-MAILIST] G.L. summary Pressure Hull

[hank pronk]

Does anyone have a trick to machining an inside taper without lathe  attachments.  I need to make a hub to fit a tapered shaft.  I made one by trial and error and it will work but it is not perfect. 
Hank 



On Thursday, December 12, 2013 7:13:39 AM, Jon Wallace <jonw at psubs.org> wrote:
  

I should have stated up front that we were just having some fun
      and I hope nobody concentrating on ROV/AUV development and
      operation takes offense.  PSUBS welcomes ROV and AUV discussions
      here as well.

Jon



On 12/11/2013 9:57 PM, Alan James wrote:

Thanks Keith, 
>hope didn't see the phone sex & ROV comments 
>earlier  
>Keith owns a ROV company. 
>Alan 
>  


_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20131212/21a8bb90/attachment.html>